On Wed, Jul 02, 2003 at 02:09:58PM +0200, Pablo Rodriguez Gonzalez wrote: > Hi Ed and others, > > First, thanks for your fast response. Youre faster than my LAN ;-) > > Ive a hub, not swith, but its running at full duplex. All the NICs > -laptop and desktop PC, desktop PC runs fine- is running at full > duplex too.
And here lies the problem. According to my network specialists at work (who should know what they're doing), there's no such thing as a full-duplex hub. Hubs are *always* half-duplex. Switches can be either half or full. Reconfigure all your NICs to run at half-duplex and try again. > eth0 Link encap:Ethernet HWaddr 00:0B:DB:95:4F:0E inet > addr:192.168.9.5 Bcast:192.168.9.255 Mask:255.255.255.0 UP BROADCAST > RUNNING MULTICAST MTU:1500 Metric:1 RX packets:576754 errors:129661 > dropped:0 overruns:0 frame:12 TX packets:26460 errors:0 dropped:0 > overruns:0 carrier:0 collisions:124 txqueuelen:100 RX bytes:449850611 > (429.0 Mb) TX bytes:2967621 (2.8 Mb) Interrupt:11 Base address:0xe000 > Memory:faffe000-fafff080 > > Its running at full duplex, but Ive thousand of errors!. Bad hardware? The errors are caused by the half/full inconsistencies. You'll be forced to retry over and over again. -- Ed Wilts, Mounds View, MN, USA mailto:[EMAIL PROTECTED] Member #1, Red Hat Community Ambassador Program -- redhat-list mailing list unsubscribe mailto:[EMAIL PROTECTED] https://www.redhat.com/mailman/listinfo/redhat-list
