I have had the same problem before. After install just restart your
computer with the install disk in the drive. Once you are at the lilo
prompt, just type rescue root=/dev/hdX. This will boot your linux
partition. Make sure the hdX is your root partition. Once booted, just
type lilo at the command prompt. The lilo.conf file should have already
been made during setup, so make sure you at least try installing lilo during
setup.
> -----Original Message-----
> From: tejedor [mailto:[EMAIL PROTECTED]]
> Sent: April 21, 1998 4:02 AM
> To: [EMAIL PROTECTED]
> Subject: Lilo´s problems
>
>
>
> I´ve tried several (>5)times to install RH 4.2 on a Pc(200Mhz + 128 Mb +
> 3 Hdd):
> hda NTFS 2.16 Gb , hdb FAT 2.16 Gb ,
> hdc1 swap 132Mb : hdc2 \ 300Mb : hdc3 \usr 1.6 Gb
> I can format the partitions of the third disk , choice the soft. to
> install ... every seems ok until i try to install lilo on 1st sector of
> root partition (hdc2) and after a while ... I get the message:
> "An error occur during step install boot loader".
> Any idea should be very very welcomed.
> Thanks
> Jose Maria Tejedor
>
>
> --
> PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
> http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips
/mailing-lists
> To unsubscribe: mail [EMAIL PROTECTED] with
> "unsubscribe" as the Subject.
>
--
PLEASE read the Red Hat FAQ, Tips, Errata and the MAILING LIST ARCHIVES!
http://www.redhat.com/RedHat-FAQ /RedHat-Errata /RedHat-Tips /mailing-lists
To unsubscribe: mail [EMAIL PROTECTED] with
"unsubscribe" as the Subject.
