Nope, just checked...

alias eth0 3c59x
alias eth1 3c59x

So that's not it.  Did help me catch a small configuration error I had
elsewhere in the startup, though (I had an incorrect and absent soundcard
driver referenced in there, along with the correct one... I removed them
all, resetup the correct sound card, and cleared that error.  Wouldn't have
thought to look there without this pointer, so thanks!).  

BTW, I made a mistake before... the actual error is:

Delaying eth1 intialization

not the "Delaying initializing eth1" message.

Bill Ward

-----Original Message-----
From: Steve Dixon [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, December 15, 1999 3:07 PM
To: [EMAIL PROTECTED]
Cc: recipient.list.not.shown; @nswcphdn.navy.mil
Subject: Re: Two NICs?


how about 'alias eth1 3c950' in /etc/modules.conf.  im sure if 3c950 is
the module or not, though.  then try to bring the interface up.

Ward William E PHDN wrote:
> 
> Ok, folks, somehow I'm having a brain freeze.  I'm having trouble getting
> two NICs working in a single box together.  Here's the setup:
> 
> RH5.2 (Stock, no new software out of the box)
> P133, 40MB
> 2 3COM 3C590-TX Fast Ethernet Cards
> 
> Everything else is probably irrelevant hardware-wise.
> 
> I'm trying to setup eth0 using DHCP as my main interface to the box (named
> Woodstock).  The DHCP is working fine.
> 
> On the other side, I'm trying to use eth1 with a fixed address (10.0.0.1)
to
> a subnet (Woodstock) as Master (yes, if you are thinking Beowulf, you're
> right).
> 
> During bootup, eth0 initializes properly and all is bright and gay.  Then
> it's eth1's turn, but instead of booting, it says "Delaying initializing
> eth1".
> 
> OooooK.  So, I try ifcfg-eth1 up and get an error that the card doesn't
> exist.  The file is in place, though, so at least Linux recognizes that
the
> nic is THERE.....
> 
> I have NOT recompiled the kernel, so the fact that there are two identical
> cards has me thinking that perhaps my problem lies in not having an alias
to
> load a second copy of the driver for the card... but can that be it?  And
> how would I need to configure that?  I don't want to hose the system with
an
> incorrect configuration.
> 
> Bill Ward
> 
> --
> To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
> as the Subject.

-- 
Steve Dixon
Dpn, Incorporated
System Administrator
Phone - 702.873.3282
Email - [EMAIL PROTECTED]


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.

Reply via email to