On Sat, Dec 25, 1999 at 05:11:16PM -0800, Ron Golan wrote:
| On Sat, 25 Dec 1999, Todd A. Jacobs wrote:
| > Sometimes, when I set the SGID on a directory, it shows with a capitol S,
| > and sometimes lowercase. Why is that?
| I'm not sure about this but...
Good, because you have it exactly backwards.
| I think if a directory has group execute permission, then setting the
| SGID will show an 'S'. If the directory did not have group execute
| permission set, then setting the SGID will show an 's'.
The setuid, setgid and sticky bits on an object are indicated in "ls
-l" by putting an s,s or t in the execute-bit position in the
permissions, respectively. It the underlying execute bit is off, that's
highlighted by capitalising the s,s,-or-t.
--
Cameron Simpson, DoD#743 [EMAIL PROTECTED] http://www.zip.com.au/~cs/
When you're no longer frightened, it's time to retire. - Mercenary proverb
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.