Hiya - I've been scratching my head over this one for quite a while -
and still have no joy :(
We have a Seagate Scorpion 12/24 on our file server and use this to
run overnight backups using BRU. I have the DIP switches set to
enable DDS-DC hardware compression I've also tried using mt to enable
compression (datcompression on) and all sorts of other tricks.
mt datcompression reports "compression on" and I can set it to off
successfully so I assume that it's reading / writing the compression
status properly?
Problem is that no matter what I try I can not get hardware
compression to work. A test that we suggested by est's tech support
dept was to do:
dd if=/dev/zero of=/dev/nst0
which should cause very little activity on the DAT drive if hardware
compression is enabled as the string of zeros sent to the tape drive
should be compressed very effectively.
unfortunately my tape drive goes into overdrive, and when I
eventually kill the dd command I find that the tape is at the same
block number as the number of blocks written by dd.
So - I'm wondering if anyone on the list can tell me a little about
their setup if you're getting DDS-DC compression to work with your
drive.
I'm using Redhat 6.0 with mt-st-0.5b-6 and the latest firmware
installed on the Seagate (supplied by their tech dept today)
thanks in advance, dan.
ps. does anyone know how I can send a scsi reset command with linux?
-----
Nitro - 3D Visualisation, Graphics & Animation
Ph (+61 2) 9810 5177 - Fx (+61 2) 9810 0199
http://www.nitro.com.au/
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.