Hi there,
I would like to add my voice to that ever-increasing chorus of
newbies with "I'm just trying my first install".
I require that it been done over the LAN (NFS, FTP, HTTP, doesn't
matter) due to their being no CD-ROM. I used rawrite to create a floppy of
bootnet.img. I get to the point where the install wants to detect my card
and autoprobe doesn't find the NIC. I tried to manually configure my
settings for the Etherworks 3 ISA card that is installed. When asked for
the module parameters I put in those of the card, namely: irq=10 io=0x300
(checked this with DEC's NICTEST.EXE).
I get a message on VC1 (Virtual Console 1) saying:"I can't find the device
anywhere on your system."
VC3 shows:
*running /bin/insmod /bin/insmod /modules/ewrk3.o irq=10 io=0x300
*insmod failed!
On VC5:
Cannot find archive member ewrk3.o: file does not exist in archive.
I found the source for this module ewrk3.c on the web, but can't
compile it because this is my first install (catch 22). Even if I could
compile it, I'm a little unsure on how to make a boot image for Red Hat's
install program. Is there an easier way to do this? I would like to avoid
using the FAT partition that is currently on the HD for running the install.
I want to make it all ext2. Does anyone have an ewrk3.o module for a P75
that they can send? If so, how do I put it into /modules (which does not
show up on the disk, I suspect it is on the RAMdisk that is created on
startup)?
Finally, assuming that I get all that working, do I set Plug'n'Play
O/S to True of False in the BIOS settings?
-------------------------------------
Robby Tanner B.E., B.Sc.
Project Engineer
Wardrop Technologies, Inc.
203-2121 Airport Dr.
Saskatoon, SK
Canada
S7L 6W5
Phone: (306) 244-4712
Fax: (306) 244-4754
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.