Bret Hughes wrote:
> Vidiot wrote:
> 
> > I currently have one LinkSys (Tulip) card in the box and will soon
> > add a second in order to talk to the in-house LAN.
> >
> > When I install the second card, is there anything that can be done beforehand
> > to make sure the current card stays eth0 and the new card becomes eth1?
> >
> > Or am I at the mercy of the BIOS?
> 
> I believe you are in the land of making sacrifices to the bios gods here unless
> the cards are isa.  I would bet with isa you will be able to set the irq/io
> addresses up so that you can distinguish between the two.  pci on the other hand
> ....

It depends on the BIOS.  You can reserve IRQs for specific slots sometimes.

But -- in general, and this is sheer superstition, the device number will 
increase the farther away from the AGP slot (or the closer to the ISA
slots if there's no AGP) you go.

You can also force the identification with an append line in lilo.conf,
IIRC.

-W-



_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list

Reply via email to