On Mon, 26 Feb 2001, Anurag Jalan wrote:
> Hi all,
>
> I recently removed SuSE 6.4 from my Compaq Armada E500 and replaced
> it with Redhat 6.2 . Since i use my laptop as a workstation on the
> LAN , i need to get my PCMCIA configured quickly.
>
> As with my previous installation, i downloaded
> pcmcia-cs-3.1.21.tar.gz and ran the usual make config, make all ,
> make install routine . This had got my D-Link DFE-650 configured
> under SuSE but there's a problem under RH.
>
> At bootup i get the following message :
>
> Bringing up interface eth0 delaying eth0 initialisation [failed]
>
> I've checked /var/log/messages : it says ' card services release does not
> match'
>
> My /etc/sysconfig/pcmcia says : PCMCIA=yes AND PCIC=i82365
> My card IS listed in /etc/pcmcia config
>
> When I manually activate eth0 with netcfg, the card works fine ! I
> can ping my eth0 IP 192.168.1.254
>
> But after a reboot it gets deactivated.. What do I try next ?
>
> Anurag
>
Is there some reasion you didn't use the
kernel-pcmcia-cs-<kernel version>.i386.rpm? I am not an expert on this,
but from the error message in the log, it sounds like a module version
mismatch in the pcmcia package.
Mikkel
--
Do not meddle in the affairs of dragons,
for you are crunchy and taste good with ketchup.
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
