Hi,
I am new to linux and have the following
problem regarding the module
ne2k-pci.o. FYI, I am runningRedhat 7.0
I have a realtek 8029 pci NIC. During
bootup, I see a message that says unresolved
symbols for ne2k-pci.o. Therefore, eth0 is not
initialized. After some investigation, I found out
that ne2k-pci.o depends on 8390.o. I found both
modules in my /lib/modules/2.2..../net/ directory.
So, I manually tried to load them by
insmod 8390.o (fine) and then
insmod ne2k-pci.o which results in again a list
of messages that say unresolved symbols.
I also tried :
depmod -a to build the dependancies. Resulted
in the same error that says unresolved symbols
modprobe ne2k-pci didn't work either (no surprise)
I'd appreciate any suggestions on how to overcome
this situation.
Thanks in advance
--priyan
PS. I am using the ne2k-pci.o and 8390.o provided
by the Redhat installation found in /lib/modules/../net
directory. The etc/modules.conf says
alias eth0 ne2k-pci
alias parport_lowlevel parport_pc
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list