Resending, as it did not get onto the list. Ted
This is a 3 part question. Part 1: When adding a network dial up extension (where the network machine is remote to the network and must dial up to get onto the network) can this incoming dial up connection be handled by the same machine which handles the internet Interface for the LAN network without compromising the Internet connection speed. I have been told that if there are two ppp ports active at the same time on the sme machine then the fastest speed of any of the two is the speed of the slowest. So this would mean that if ppp0 normally ran at X rate when handling Internet traffic, and if ppp1 was active at Y rate (being slower than X) then ppp0 would be forced to also run at Y rate???? Part 2: Does anyone know of or has used a hardware solution that will automatically handle 2 to 4 dial up connections and route them to a network hub or LAN connection point so the dial up connection occurs transparent to the network (LAN) computers. This means that if a dial up occurs to this device the entire process of interconnection to the local network is transparent to any other machine on the network and so connected there these remote dial up machines become part of the network collection of machines????? Part 3: (two questions) Where is recent HOWTO information on configuring a Linux machine, both hardware and software to be the kind of interface as explained in Part 2 above and does this require more power than available in a dedicated 486x66 machine configured just for that purpose???? Thanks for any help. Bye-thanks_TED
