>On Thu, 11 Apr 2002, daniel wrote:

> i'm trying to install skipjack (or any release for that matter) onto an old
> 486 that doesn't allow booting off the cd.  so i made a linux startup disk
> and it seems to work... but only for so long.  after i get the start up
> screen and the prompt:
> 
> boot:
> 
> and i hit <enter> it seems to go through the start up / install process and
> then stops with the following messages:
> 
> running /sbin/loader
> install exited abnormally -- received signal 11
> sending termination signals...done
> sending kill signals...done
> disabling swap...
> unmounting filesystems...
>     /proc done
>     /dev/pts done
> you may safely rebot your system
> 
> 
> what went wrong?
> 
>
Signal 11, or officially know as "segmentation fault", means that the program  
accessed a memory location that was not assigned. That's usually a bug in the program. 
But, if you read "sig11 FAQ" at http://www.bitwizard.nl/ you will see that there are 
also hardware issues specific to RedHat 5.x,6.x, and 7.x installs.

Make sure you are installing from "real DOS", and not from a "DOS window", and that 
you don't have any TSRs installed in your autoexec.bat or config.sys. You may have a 
bad floppy disk. 

Try booting with a Win98 boot disk - select "dos prompt with cdrom support." At the 
DOS prompt, cd\dosutils and run:
autoboot.bat   <enter>

                                                                                 
Regards,

                                                                                  Tom 



_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list

Reply via email to