Since you do not indicate how you are supporting the nics I am going to
guess that you are using modules since they both work with the boot
disk.  I would recommend you look at your kernel config setup for
network drivers and see how the two cards are supported, more than
likely it will say module for both (or kernel for the linksys and module
for the 3com).  If it says module make sure that you have the modules in
the right place, then make sure your /etc/modules.conf lists them.  If
you have kernel source installed you will get a lot of information in
the
 /usr/src/linux-2.4/Documentation/networking directory that should prove
helpful.  

Hope this helps.

John



>Message: 4
>From: "BG" <[EMAIL PROTECTED]>
>To: <[EMAIL PROTECTED]>
>Subject: RE: Redhat 7.2 and 2 nics
>Date: Tue, 16 Apr 2002 09:20:11 -0700
>Reply-To: [EMAIL PROTECTED]
>
>I have run RH Linux for many years with 2 nics.  I only have problems
when I try to use an ISA 
>card.  I never have any problems when I use 2 PnP cards. Perhaps the
problem is not with the nics, >but with the network config?
>
>Bill
>
>> -----Original Message-----
>> From: [EMAIL PROTECTED] 
>> [mailto:[EMAIL PROTECTED]]On Behalf Of Kjetil Tjensvold
>> Sent: Friday, April 05, 2002 3:53 AM
>> To: [EMAIL PROTECTED]
>> Subject: Re: Redhat 7.2 and 2 nics
>>
>>
>> Redhat 7.2 has problems with 2 nic's.
>> That my experience also.
>>
>>
>>> --- Delane Jackson <[EMAIL PROTECTED]> skrev: > I
>>> have 2 nic cards on my machine.  I am triple
>>> booting
>>> Windows 2000 Advance server, Windows XP, and Redhat
>>> 7.2.  After re-installing linux for whatever reason
>>> both cards come up fine.  When I reboot for whatever
>>> reason only eth0 which is a linksys card comes up.
>>> Before the linksys card would not come up and the
>>> 3com
>>> card would when the 3com card was eth0 (past
>>> installation).  Checking
>>> /etc/sysconfig/networking/devices lists both
>>> ifcfg-eht0 and ifcfg-eth1 both configured the same
>>> with the exception of DEVICE=eth0 and DEVICE=eth1.
>>> I
>>> tried to ifup eth1 and it eventually fails.
>>> However,
>>> when I boot using the boot disk both interfaces
>>> comes
>>> up just fine.  Can someone please make sense of
>>> this.
>>> I am not sure what to do.
>>> D
>>>

John B. Hough
[EMAIL PROTECTED]
[EMAIL PROTECTED]
[EMAIL PROTECTED]
[EMAIL PROTECTED]
Something is bound to reach me..... . . . .  .  . 




_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list

Reply via email to