I just bought a linksys 4 port DSL router/gateway that supposedly does
NAT (on the box it says it does). I just spent 1 hour digging through
every menu and see no way to configure NAT.
Question regarding the Linux firewall project. Can a Linux firewall
support most of the features of the PIX firewalls?
I need to do the following (all at the same time)
1) Let private addresses behind the firewall access the internet (DHCP)
2) 'NAT' real addresses to private addresses behind the firewall
ie: some.routable.address.1 to 192.168.1.100 (if you are familiar
with a PIX this would be a [nat (int1, int2) IP addresss netmask] and
then you would add X number of conduits to allow access to your services
3) At the same time as 1 and 2 above, allow a highly-configurable method
for limiting access to ports (ie Allow some IPs thru the firewall, block
others, etc...)
ie: Allow ssh from <ip address> thru the firewall to <ip address>
(with the second IP address being 'NAT'ed thru.)
By NAT, I man the following:
I have a linux PC with an internal address, say 192.168.1.10. With a NAT
capable firewall/router, I can specify that the real address
64.58.76.225 is NAT'ed to 192.168.1.10 on the secure (internal)
interface. Thus traffic destined for 64.58.76.225 is routed to the
192.168.1.10 interface of the linux system (I think it does a packet
header rewrite). Also, outgoing IP sessions from the linux PC seem like
it is coming from 64.58.76.225. At the same time, you can define complex
rules delegating what source IP have access to what, if any, services on
the linux PC.
Will a Linux firewall work in such a way?
Thanks,
Chuck
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list