Anyone able to figure this one out?
----------
PCI: PCI BIOS revision 2.10 entry at 0xfb1a0, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 2: assuming transparent
PCI: Using IRQ router PIIX [8086/24c0] at 00:1f.0
PCI: Found IRQ 7 for device 00:1f.1
PCI: Sharing IRQ 7 with 00:02.0
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)
Starting kswapd
VFS: Diskquotas version dquot_6.5.0 initialized
pty: 512 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT SHARE_IRQ
SERIAL_PCI ISAPNP enabled
Real Time Clock Driver v1.10e
block: 976 slots per queue, batch=244
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PCI_IDE: unknown IDE controller on PCI bus 00 device f9, VID=8086, DID=24cb
PCI: Device 00:1f.1 not available because of resource collisions
PCI_IDE: (ide_setup_pci_device:) Could not enable device.
----------
The IDE bus is working, the drives are working just fine. But why am I
getting the above error? Why does it come up as a 33MHz bus?
The motherboard is a brand new SuperMicro P4SGA board, P4-1.8Ghz, 512MB DDR
ram with a 400Mhz front bus speed. So, what's going on?
--
H | I haven't lost my mind; it's backed up on tape somewhere.
+--------------------------------------------------------------------
Ashley M. Kirchner <mailto:ashley@;pcraft.com> . 303.442.6410 x130
IT Director / SysAdmin / WebSmith . 800.441.3873 x130
Photo Craft Laboratories, Inc. . 3550 Arapahoe Ave. #6
http://www.pcraft.com ..... . . . Boulder, CO 80303, U.S.A.
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@;redhat.com?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list