On Friday, November 8, 2002, at 03:29  PM, Simpson, Doug wrote:

I am trying to set up a gateway with RH7.3 and IPSEC. I have reconfigured
the kernel with the latest freeswan and x509. It boots with no problems. I
then try to connect to it with SSHSentinel off a win2k laptop dialed into
the internet. I have not put a firewall on this yet (I will).
I get the message on both ends that ike is not supported. The SSH client is
saying The remote end does not respond tothe IKE proposal (phase-1) or the
gateway does not initiate the IKE config mode.
And on the RH box in /var/log/secure "oakley_des_cbc not supported".
On freeswan they say it is the client, but I have made sure I am running 3
des on the ssh client.
Can the ssh client run in a debug mode to check that the IKE proposals match? When you do this, the IKE proposals on both sides have to match exactly - the cipher (3DES), the integrity alg. (MD5 or SHA1), the authentication method (x.509 or pre-shared secret), etc...

--
Jason Costomiris <><
E: jcostom {at} jasons {dot} org / W: http://www.jasons.org/
Quidquid latine dictum sit, altum viditur.



--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@;redhat.com?subject=unsubscribe
https://listman.redhat.com/mailman/listinfo/redhat-list


Reply via email to