Thanks Tom, will see how it works out. Mathew
----- Original Message ----- From: "Tom Manning" <[EMAIL PROTECTED]> To: <Repeater-Builder@yahoogroups.com> Sent: Wednesday, May 12, 2004 2:05 PM Subject: Re: [Repeater-Builder] DB-304 Antenna Help > Mathew > The harness was changed because it was both bad and needed changing to > accomodate the retuning. Generally the higher freq harness is not long enough > to allow the dipoles to be moved to where they should be. Some people have used > the harness and dipole placement as they were originally but with a slightly > higher VSWR. This does not give you the best pattern either. > 73's de Tom Manning, AAF4UG > > > Mathew Quaife wrote: > > > > Mathew > > > I am not familiar with that particular model antenna. I currently > > > use a DB224 antenna that I modified about 10 years ago for use at > > > 145.49Mhz. I figured how much to lengthen the loops by using ratio and > > > proportion, I then cut the loops and added the necessary aluminum rod. > > > I had the added rod and all aluminum connections heliarced. The antenna > > > has a very low VSWR and has given many years good service. This is not > > > bad for a recycled commercial antenna that cost nothing but a $200 > > > > Was the harness changed to accomodate the antenna retunning, or to replace a > > bad one.? > > > > Mathew > > > > > phasing harness and a good deal of work. > > > 73's de Tom Manning, AF4UG > > > <[EMAIL PROTECTED]> > > > > > > > > > w9mwq wrote: > > > > > > > I have DB-304 antenna that at 156.100 gives a 1.2 VSWR at 50 ohms, > > > > looks real good. I want to use this antenna at 146.925, shows a > > > > VSWR at 1.5:1 at 74 ohms. What could be done to get this to a 50 > > > > ohm impedance? All help would be greatly appreciated. > > > > > > > > Mathew > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/