This is very esay! The pin marked hook. Send this over to your COR, set it up so when it see's a carrier it goes to high or away from ground. this will make it so that the comm-spec bd stops the tone when there is no carrier. I did this for ILRP so that I would not transmitt the ID to ILRP. Good luck, Russ, W3CH
----- Original Message ----- From: "Steaven Rogers, W4YI" <[EMAIL PROTECTED]> To: <Repeater-Builder@yahoogroups.com>; <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]> Sent: Thursday, June 03, 2004 12:19 AM Subject: [Repeater-Builder] PL on a MASTR II > This has probably been asked before, but I didn't pay attention then. I > have a MASTR II and a ComSpec SS-64 Encoder. I am needing to hook the > encoder up so that it transmits a tone ONLY when the repeater RX is > active. Also, the controller is a CAT-300DX if that makes a > difference. Can anyone tell me the easy way to do this? > > Thanks > > Steaven, W4YI > IRLP Node 7520 > > > > > > > > Yahoo! Groups Links > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/