Regarding the time out problem in the GE Mastr II, check the repeater control board, 19D417385 G2 and add a .01 capacitor from pin 5 of U-1 and U-2 (555 timers) to ground. These were ommitted by GE for some reason, and if missing can make these timers unstable.
Quoting the Sams 555 timer applications sourcebook, Page 18: "If the control pin (Pin 5) is not used, it is recommended that it be bypassed to ground with a .01 mfd capacitor to prevent any noise from altering the calculated pulse width" 73 John VE3AMZ Waterloo, Ontario. ----- Original Message ----- From: "John J. Riddell" <[EMAIL PROTECTED]> To: <Repeater-Builder@yahoogroups.com> Sent: Thursday, July 29, 2004 10:15 PM Subject: Re: [Repeater-Builder] GE Mastr II/IDA Controller - Selective COR? | We had a similar problem here about 20 years ago on VE3RSO....a fully | commercial set-up | Mastr 11 repeater and as I recall it was a 555 timer that needed a .01 Mfd | bypass installed on one of the | leads....I'll try to dig thru my notes to see if it was documented. | It's on one of the boards in the control shelf. | | John VE3AMZ | | | ----- Original Message ----- | From: "derek_mcintyre" <[EMAIL PROTECTED]> | To: <Repeater-Builder@yahoogroups.com> | Sent: Thursday, July 29, 2004 9:54 PM | Subject: [Repeater-Builder] GE Mastr II/IDA Controller - Selective COR? | | | | I am using a full blown GE Mastr II repeater station with an IDA | | control board (I suppose this is a factory installation). It has a | | speaker on the front, with a volume control and a few selector | | switches, and jumpers on the board which select time out, hang time, | | etc. I have a CW identifier interfaced as well. | | | | I am not using any additional controller with this station and am | | having a strange problem. Quite often, the repeater seems to "drop" | | users. It's not a time-out timer problem. Users will be talking. | | One will un-key, and the next one will pick it up, but the repeater | | will NOT repeat! When he finally unkeys, the next user will pick it | | up and it will work just fine. It's not one user in particular. | | There is no time frame associated with it. It's like the unit has | | selective COS. It drops whoever it wants to. | | | | Is there anything that you can think of that would make this happen? | | I have changed hang times all over the place, even took the time out | | timer to 10 minute mode. In the manual there is a "master" timer but | | I don't think this is a timing issue. If I can't get this | | straightened out, I'll probably wind up having to put an external | | controller on the thing. Any suggestions? | | | | Thanks | | KC4FWC | | | | | | | | | | | | | | | | Yahoo! Groups Links | | | | | | | | | | | | | | | | | | Yahoo! Groups Links | | | | | Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/