Daddy, are we there, yet?
Are we there, yet? Are we there, yet? Are we there, yet? Are we there, yet? Are we there, yet? Are we there, yet? Are we there, yet? Kenneth Buley Bullitt County DES CD-2 Bullitt County Red Cross/Certified ECRVDriver/Operator BC-6 Bullitt County ARES\RACES Coordinator KY4DES -----Original Message----- From: Mathew Quaife [mailto:[EMAIL PROTECTED] Sent: Saturday, December 18, 2004 12:29 PM To: Repeater-Builder@yahoogroups.com Subject: Re: [Repeater-Builder] Source for custom made cables I wished it was available. I had several of these cables but tossed them all out about 5 years ago when I thought I was done playing with radios. Just go to show keep it, you never know when you will need it. Mathew ----- Original Message ----- From: "Q" <[EMAIL PROTECTED]> To: <Repeater-Builder@yahoogroups.com> Sent: Saturday, December 18, 2004 6:35 AM Subject: Re: [Repeater-Builder] Source for custom made cables > > I'd use the origional GE cable if available. I'm not fond of RCA's but > the factory cables have proved better than anything I ever made. 73,Lee > > Mathew Quaife wrote: > > >I think the point was mistaken here. I either have to change the connector > >on the receiver so that the cable goes directly to the receiver without > >using any connetors to change from one type of plug to another, or find a > >special cable with an RCA on one end and a Type N Male on the other. My > >objective is to never visit the repeater site once this machine is done. > >And if I have to, I don't want it to be becuase I used a cheap connector to > >tie in the reciever. The receiver is the GE MASTR ER41. I'd rather just > >change the connector to a type N connector, but would have to widdle a > >little on the internal copper casing to put it in place. Question: If I > >install the type N connector, and there is a solder point behind the inside, > >am I going to run into troubles. I hate to cut into it to find that I'm > >opening a can or worms for noise to get in? > > > >Mathew > > > > > > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
