John,

The 10 Feet between antennas will work fine but you
WILL NEED to install Dual Isolators, that have 70 db
of isolation, on each transmitter before going to the
cavity or duplexer. If you don't you will be
generating Intermod from your transmitters that will
be heard for several miles. The use of an Isolator
will reduce the amount of Intermod or "IM" that will
be generated by your repeater transmitters because of
close proximity of your antennas.

The output of 442.150 will be radiated by its antenna
and picked up in the nearby antenna and sent down the
coax into the PA of the 442.175 transmitter and mixed.
This generates a new frequency of 442.125 which then
can go out the coax and into the antenna to be
radiated out to be heard. You will also generate
442.200 going the other direction. This is the 2A-B or
2B-A intermod mix.

It gets more complex with each new transmitter.

Telewave had a good article about the use of Isolators
at multiple transmitter locations on their web page at
one time but it is not there now.

Here is where you can find spec sheets on the Telewave
 brand of Isolators:

http://www.telewave.com/pricelist/isolatordat.html

There are a number of Isolators manufactures on the
market. 

Thanks,
 
John Lloyd, K7JL
Intermountain Intertie
www.ussc.com/~uvhfs/snowlink.html

***********************************

Message: 3         
   Date: Mon, 28 Feb 2005 14:22:15 -0000
   From: "johnmichaelwelton" <[EMAIL PROTECTED]>
Subject: Colocating second UHF rptr


I have a site on top of the local hospital with 3 2in
galvanized mounts attached to the roof separated by
~5ft each. On the first two I have a DB404 on
442.150/R [abt 50 watts out of the duplexer] and the
middle mount is a DB224 on 147.390/R [also abt 50
watts out of 
the duplexer]. I'd like to put a second UHF rptr at
the site on the open third mount and dedicate to VOIP
application [I have a dedicated LAN on emergency power
and T3 lines to campus]. I'm considering putting up a
DB411 and using either 442.125 or 442.175 as potential

freqs (both are available here) thinking that the
respective duplexers will help notch out the adjacent
tx signal some and will still have ~5Mhz split between
TX and RX. The only other options I have is a roof
vent that could support maybe an X50 or something
equivalent that is very small and this is on the main
roof one floor below and abt 100 ft away from the main
442.150 antenna (I have 1/2 in LDF4 to run there).

Any comments if the 10ft or so between the two UHF
antennas will work?

John/N4SJW
Charleston, SC


                
__________________________________ 
Do you Yahoo!? 
Yahoo! Mail - 250MB free storage. Do more. Manage less. 
http://info.mail.yahoo.com/mail_250




 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



Reply via email to