> Adam, Are there any voltage test points on this radio in which
you can test VCO? Also, are the front end coils the 4 in a row on
the bottom of radio???
Thanks again in advance!!!!
Just go back and forth across the front end coils for best
sensitivity
> over the frequency spread you would like to have, and you are set
to go.
> You should also adjust the TX and RX VCO's - the RX should be set
where it
> gives best performance and sensitivity IN SCAN, or you will not
receive
> all your channels in scan mode correctly. There is also a mod for
locking
> the noise blanker on full time, that I created for my 1011's, and
it works
> well. Good luck...
>
>
> At 05:01 AM 3/12/05 -0000, you wrote:
> >
> >
> >
> >I have a vertex ftl-1011 lowband radio that i tuned up to TX/RX on
52
> >MHZ. Does anyone have advice on how to adjust the front end for
> >optimum RX?
> >
> >
> >Thanks, Rob
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >
> >Yahoo! Groups Links
> >
> >
> >
> >
> >
> >
> >
> >
>
> - Adam -
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
