Back in the 'earlier days of radio' ... that's the Motorola T44A6A Receiver for those of you who were around back then and can still appreciate those days ...
We removed the stuck slugs by using drill bits ... hand inserted into each slug and carefully reaming out the center. Once that drill bit cleared the stuck slug, we used the next size larger drill bit ... until the remaining parts collapsed and fell out. Just our successful method. Batteries not included / your mileage may vary. Hope this helps, Neil - WA6KLA Larry Lockard wrote: > > Sorry all .... Should have said it was a mobile...I forgot GE was dumb > enough to give the same designation to different types of radios. > > Also the 4 slugs are not only stripped but if like the others on the board > that I did get loose these will be stuck .... tight. Pointers before I > replace them gladly accepted. > > I would consider buying a whole radio depending on the price or just another > exciter board or if someone has a spare.... GE Custom MVP UHF Mobile - board > needs to be capable of moving to 444 mhz area of the ham band (no tripler > please). As I say I'm going to duplex it and I've told to avoid the tripler > versions. > > Thanks > Larry > ----- Original Message ----- > From: "Q" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Wednesday, March 16, 2005 9:59 AM > Subject: Re: [Repeater-Builder] GE MVP tuning slugs > > > > > MVP handheld or is it a Custom MVP mobile? I have had some luck with > > carefully drilling out the old slugs and replacing them on Custom MVP's. > > It may be less work to just get another exciter board and change it out. > > They are certainly cheap enough. > > > > Paul Finch wrote: > > > >> Larry, > >> > >> If I remember correctly that hand held radio has modules, have you > >> taken the exciter out and tried to turn the slugs out from the other > >> side? Normally only one end of the slug is stripped. Remember, it's > >> been 20 years since I worked on one of those radios. > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/

