I know someone had mentioned a need for components from a Kenwood TK
722R (or something like that) repeater.
I have parts from what I believe to be that configuration. The whole
setup got scrapped out for the power supply, and I managed to salvage
the RF Deck which seems to have 2 separate PA units, but only one coax
connector, the COR board, and what may be a controller board.
Transceiver/RF Deck: TK-722R FCCID: ALH9TKTK-722R-1
Seems complete. PA "Bricks": M57706 and M67731
COR Board: SSC, Model 823 T-A2-1702-0
Has two 6 terminal - terminal blocks, 11 pin header, Relay, Tran and
Recv vertical trim pots..
Controller Board?: X52-3080-20 J25-6546-02
This board has 6 switch dipswitch bank labeled "TONE FREQ"
Trim Pot "TONE DEV"
4 pin header CN2 12 pin header CN1
LSI SMT Device MN6520
Sorry for the lack of knowledge and poor descriptions.
I will not be needing this, and could use a entry level controller or
CWID board for a repeater project using a VHF Engineering 2m repeater
that I want to donate to an adjacent county for Skywarn access by the
NOAA station that polls regional repeaters for spotter info.
David
KD4NUE
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
