Some of the module/card or back-plane jumpers are set for base station (half duplex) operation.
skipp > "let_cyber" <[EMAIL PROTECTED]> wrote: > > I have both a vhf and uhf Micor repeater that I'm interfacing. > > I now know a whole lot more about Micor repeaters than I really wanted > to. The short version of the problem is as follows: > > The COS signal from the audio/squelch board goes away when the TX is > enabled. If you transmit a continuous carrier on the input, The COS > comes up for a split second, keys the TX then goes away. After the > hangtime expires and the TX drops, the whole things starts again. > > I have the exciter and RX into 50 ohm loads. If i put the A/S board > and squelch gate into the uhf unit, it works fine. I have checked and > double checked everything. It just doesnt make any sense. Any ideas > would be greatly appreciated. > > Al KB2AYU > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/