> Access to the AXX and DXX control codes can be enabled or disabled > with two > control codes; Control Code enable and Control Code disable. When > disabled the > only control code to function is the Control Code Enable. These codes > do NOT > affect access to the * and # user codes. >
The above is from the RC-1000 manual. This means that you have to enter the two unlock codes in the proper sequence to do any of the 'A' or 'D' functions. > Repeater enable 4100 A_ _ > Repeater disable 4101 A_ _ To enable the repeater, issue the A__ code (whatever has been programmed in with the 4100 command). Remember to unlock the controller before entering the code. To disable the repeater, unlock the controller and then enter the A__ code that was programmed with the 4101 code. > External ID en/dis 4140 D_ _ With the controller unlocked, enter the code that was programmed for the 4140 function (Dxx) to switch to external ID. We used this to allow EchoLink to ID a repeater and stop our ID from propigating down the EchoLink connected station. > CW ID timer interval 4076 _ _ @ 3C = 8 minutes Or you could set the CW ID timer interval to 00 to disable the CW ID. ie, with the controller unlocked, issue the command 407600. The 3C value would set the ID interval back to 8 minutes. Remember to lock the controller with the lock code when you are finished. The controller will respond with a low-high tone when a function is turned on, and with a high-low tone when it is turned off. I hope some of this helps - 73 - Jim [EMAIL PROTECTED] Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/