Been there, done that. They don't have them, and can only get them in multiples of 1000! That's why I need a source. Mike
Gary Schafer wrote: > > > Go to your local electronics supply house. They should have them. Ask > for instrument fuses. > > > > 73 > > Gary K4FMX > > > > ------------------------------------------------------------------------ > > From: Repeater-Builder@yahoogroups.com > [mailto:[EMAIL PROTECTED] On Behalf Of Mike Pugh > Sent: Wednesday, February 07, 2007 8:50 AM > To: Repeater-Builder@yahoogroups.com > Subject: Re: [Repeater-Builder] Low sens on a 2600 monitor > > > > Sorry to butt into this conversation, but I need a source for these > fuses. I have a 2001D monitor, that takes a 1/8a fuse.. Any of you guys > able to help? Mike KA4MKG > > Eric Lemmon wrote: > >> >> >> Ben, >> >> Both the GEN and the ANT connectors have 1/16 ampere pico fuses behind > them, >> just in case the technician keys a transmitter while connected to them. It >> must happen a lot, since fuses were provided. It takes a 7/16-inch nut >> driver to remove the connectors, and the pico-fuse plugs into the back of >> the connector. Check the fuses for continuity to ascertain if that's the >> problem. Extra fuses were included in a small envelope packed in the >> instrument cover storage compartment. Exact replacement fuses are > available >> from Digi-Key as #F2307-ND at $1.19 each. >> >> If you need to get back in operation before your replacement fuses arrive, >> just switch the GEN and ANT connectors. >> >> 73, Eric Lemmon WB6FLY >> >> -----Original Message----- >> From: Repeater-Builder@yahoogroups.com > <mailto:Repeater-Builder%40yahoogroups.com> >> <mailto:Repeater-Builder%40yahoogroups.com> >> [mailto:Repeater-Builder@yahoogroups.com > <mailto:Repeater-Builder%40yahoogroups.com> >> <mailto:Repeater-Builder%40yahoogroups.com>] On Behalf Of w4wsm >> Sent: Tuesday, February 06, 2007 6:02 AM >> To: Repeater-Builder@yahoogroups.com > <mailto:Repeater-Builder%40yahoogroups.com> >> <mailto:Repeater-Builder%40yahoogroups.com> >> Subject: [Repeater-Builder] Low sens on a 2600 monitor >> >> Well just found this group so here is another question...last for now >> I promise:-) >> My 2600 service monitor has lost a lot of its hearing. It's still 100% >> on everything else, but it has lost a lot sens. It was just one of >> those turn it on and what happened type of thing. >> >> Any ideas on this one? >> >> Thanks! >> Ben >> >> > >