> I'm presently setting up 4 Delta SX UHF Transceivers as Tx'ters for a > repeater system. I have completed the mod and am presently trying to > tune radios. The problem I'm having is that my dev is up to about 9.8 > kHz. My service manual says to adjust R237 (Dev Adj). The > radio that I > am working on does not have R237.
There are several revisions to the Delta-S and Delta-SX TRS boards; the component labels and locations may be different than shown in your manual. The voice deviation pot should be hidden under the shield covering up the synthesizer/TRS area of the board (the rear compartment as viewed with front of the radio toward you). The pot is accessible through a hole in the shield. It's along the edge of the compartment closest to the front of the radio, a little right of center. The pot is adjusted with a hex diddle stick. Usually these pots have either a white or red plastic cap on them (similiar to the pots used for setting the level of volume-squelch high, and for setting power output in the PA); you should be able to see it through the shield cover if you look with a flashlight. There is also a pot for modulating the VCO (for low frequencies/DPL), which is in the upper-right, but shouldn't normally need to be adjusted unless you're using DPL, in which case, follow the procedure in the manual. --- Jeff