Hello Mike, I'm sure that was it's intended purpose but it is not responding to the frequency that is noted on the top of the crystal can. We did not follow up because it is to easy for me to run up and shut the thing down if needed. I will have to do a little more study on the 70cm receiver.
73 Bob WB6ODR ----- Original Message ----- From: Mike Perryman To: Repeater-Builder@yahoogroups.com Sent: Tuesday, April 17, 2007 9:55 AM Subject: RE: [Repeater-Builder] Thanks for the info Our Micro is on 2 meters and has a 70 cm receiver in the cabinet who's frequency I don't know. Need to find that out!! ^ control receiver maybe??? just a thought... 73 Mike Perryman www.k5jmp.us -----Original Message----- From: Repeater-Builder@yahoogroups.com [mailto:[EMAIL PROTECTED] Behalf Of Bob & Linda Smith Sent: Monday, April 16, 2007 8:47 PM To: Repeater-Builder@yahoogroups.com Subject: [Repeater-Builder] Thanks for the info Thanks Nate, I've put your email in the special folder on our repeater.. I remember when I was with the Phone Co., we did just what you are suggesting.. Wrote it all down, twice or three times, that was before digital photos of course.. 73, Bob Smith WB6ODR, Prescott, AZ ----- Original Message ----- From: Nate Duehr To: Repeater-Builder@yahoogroups.com Sent: Monday, April 16, 2007 4:24 PM Subject: Re: [Repeater-Builder] Rethinking the Possible poll question On 4/15/07, Bob & Linda Smith <[EMAIL PROTECTED]> wrote: I think our Micor must have been properly converted because it has been on the air for about 25 years according to the original owner who I talk with 2 weeks ago. Our Micro is on 2 meters and has a 70 cm receiver in the cabinet who's frequency I don't know. Need to find that out!! The main reason for a possible change of equipment is the possibility of some digital work later on. Thanks for the pointers. Bob WB6ODR Side note for your project there Bob, Just because it was "on-air" doesn't mean it performed well, or even to spec. If you have things like a UHF receiver in the cabinet that you don't know what it is, now is the time to document, document, document... Later on, you'll certainly want to know things like, "Just where is that wire from the controller hooked to", and digital photos, drawings of all wiring, etc... are what you'll need. Attack the thing with a label maker too, and label every cable interconnect and every port they plug into. Take lots of pictures. Go nuts. Digital is cheap. Next, find someone with the right test gear and measure all the basics as it's installed at your site. Receiver sensitivity off and on the antenna system, transmitter power level, duplexer isolation, feedline losses... whatever you can measure, and write it all down somewhere -- start your "engineering book" for the repeater system, and then require that if changes are made, the docs get updated. You'll be happy you did later. And as friends say, if you haven't measured -- you don't know where you're starting from... Nate WY0X