It is a repeater Tom, What happen is I screw up, I read the Desktrac and save the file on the archive, after that I reprogrammed the two maxtrac, to 444T900 and 449R900 it work as a repeater, The mistake I did was I try to save it again, and it overwrite the old archive, then I try to program the Desktrac by pulling the archive and change the ctcss to tone, then program back to the Desktrac, for some reason it lost the front panel info, now when you read, it says can not read the unit serial number and model number. that's what happen when you gets old and screw thing up.
w4cso ----- Original Message ----- From: Thomas Oliver To: Repeater-Builder@yahoogroups.com Sent: Wednesday, August 20, 2008 10:33 AM Subject: Re: [Repeater-Builder] Re: Desktrac UHF 40 Watts Repeater Default Archive Maybe it is not a repeater? Is there two transceiver chassis in the desktrac? tom ----- Original Message ----- From: Camilo So To: Repeater-Builder@yahoogroups.com Sent: 8/20/2008 8:03:08 AM Subject: Re: [Repeater-Builder] Re: Desktrac UHF 40 Watts Repeater Default Archive Thank You Mike, now I know what Joe was explaining TWO software means, But I don't have a problem programming the Maxtrac on out of band, that I already did, my problem was in the programming of the Desktrac front panel, to tell the CPU on the front panel that it was a repeater, because what I have is blank, that is why I am asking the help of this group for the front panel default archive that I can dump the info to the front panel, maybe its not a share item??? Thanks 73 W4CSO ----- Original Message ----- From: Mike Morris WA6ILQ To: Repeater-Builder@yahoogroups.com Sent: Wednesday, August 20, 2008 3:39 AM Subject: Re: [Repeater-Builder] Re: Desktrac UHF 40 Watts Repeater Default Archive At 06:50 PM 08/19/08, you wrote: Hi Joe, I am not aware that there is 2 separate software that is use on Desktrac, What is the version of the software that program the front panel? So that I can order it from Motorola, to my knowledge the only software that is needed to program the Desktrac is RVN4080 version R03,04,00. When you try to read the unit a screen pop up to tell you turn the switch to position 3, then 2, and 1. same as programming the unit, all I need is the default archive to clone the unit. Any one on this group Please correct me if I am wrong. 73 W4CSO See < http://www.repeater-builder.com/maxtrac/maxtrac-index.html> for Desktrac RSS info. Mike WA6ILQ No virus found in this incoming message. Checked by AVG - http://www.avg.com Version: 8.0.138 / Virus Database: 270.6.6/1621 - Release Date: 8/19/2008 6:53 PM