--- In [email protected], "Ian Miller" <[EMAIL PROTECTED]> wrote:
>
> Fellows
> 
> I have a MAxar 80 mobile MD34tsa1800A sitting on the shelf here.
> 
> Its a 25 watter according to the side plate.
> 
> I'd like to make use of the PA section on our Hamtronics unit to 
> experiment, to see if extra RF out will cause any desense.  It looks 
> pretty beefy on the heatsink for a trial run.
> 
> Here is my problem. Aside from the small RF in and out cables, there 
> are 5 leads that go to the main board.  I will assume they are for B+ 
> and some sort of TX switching. I dont need any TX switching as the 
> amp will be in the TX line of the repeater.
> 
> Has anyone got a wiring diagram for the MAXAR handy?
> 
> I've looked on some manuals sites with no luck.
> 
> Thanks
> 
> Ian
> VA2IR
>
Ian,

>From my UHF Maxar manual   68p81028e75-O  ...

The White wire is "Driver controlled a+ to collector of Q802 on Main
ckt board. It attaches to the collector of Q603 on the PA.

The Red wire is "Switched A+ from Main board" which attaches to the
emitter of Q603.

The Black wire is "To Emitter of Q802 on Main Ckt Brd" which attaches
to the base of Q603.


The above three wires control the "Power control driver stage" which
is Q603 on the PA.

There is also a note that states that the voltage on the collector of
Q603 should be "8-12 V DC in transmit mode (adjustable)"
It would seem to me that by applying the 8-12 V DC to the white wire
(which is connected to the collector of Q603) you would have manual
control of the power out.  (leave the Red and Black wires disconnected) 

SOMEONE PLEASE CORRECT ME IF I AM WRONG I AM NOT A "MOTOROLA TECH"
JUST A HAM WITH SOME ELECTRONICS BACKGROUND...

The Red with White tracer is "Switched A+ Via R801 on Main board"

The White with Red tracer is "PTT from MIC" which according to note 5
is 0 VDC or ground in transmit mode.

This is from a "MAXAR" manual and not a "MAXAR 80"
My Manual is for a 15 Watt PA not the 25 watt you have...

BUT... maybe its the same....

KB8STB


Reply via email to