Read the MaraTrac articles. Modify the programming software and see how it
works. You might have to add some ferrite cores in the RX front end coils to
bring the sensitivity up a bit at 28 MHz, if you need to go that low, but as
the radio is already spec'd to 29.7 and you probably don't need much lower than
29.6, it will most likely make it without modification.
Let the rest of us know how you make out.
Bob M.
======
--- On Tue, 10/21/08, Ethercrash <[EMAIL PROTECTED]> wrote:
> From: Ethercrash <[EMAIL PROTECTED]>
> Subject: [Repeater-Builder] Low band Maratracs on 10m
> To: Repeater-Builder@yahoogroups.com
> Date: Tuesday, October 21, 2008, 6:20 PM
> I see a lot of discussion about 6m conversions for
> Maratracs... I'm
> curious about using the low-split model (RF board HLB4099)
> on 10m FM.
> The stated range for these units is 29.7 - 36 MHz roughly.
> Not a
> huge stretch down into the 10m repeater band. I have a 10m
> repeater
> in the conceptual stages, and I've had good results
> with Maratracs on
> high band and 440. I'd really like to use them on this
> machine too.
> Any wisdom offered is certainly appreciated.
>
> Thanks and 73's de N4BWP
> Brian
