at the time Maxon sold the 4450 repeater we got one and put it in service. 200 ft tower with TX and rx combiner system AC cooled area well it lasted there about 1 week before it was returned to Maxon. it has very light use but there was problems it has a Zetron 37 tone panel and a nice case the other rx in the room gave it many problems. also it was factory set to 1/2 power of the radio normal output.
----- Original Message ----- From: Jim Miller WB5OXQ in Waco To: [email protected] Sent: Wednesday, February 18, 2009 9:59 PM Subject: Re: [Repeater-Builder] MAXON SMP-4000 PROGRAMMER HELP Contact me direct and I will see if I can help WB5OXQ. Find me in QRZ if you need my email address I should have the software and cable needed to program the 4140-4450 radios. At one time Maxon offered a repeater using 2 of these radios. I will see tomorrow when I am at my shop if the software allows ham frequencies to be programmed. I think so but I am not absolutely sure. ----- Original Message ----- From: [email protected] To: [email protected] Sent: Wednesday, February 18, 2009 9:38 AM Subject: [Repeater-Builder] MAXON SMP-4000 PROGRAMMER HELP Hello Group, I am searching for a manual, or pdf for a Maxon SMP-4000 programmer. I am attempting to use two Maxon 4150 radios as a emergency rpt. . While I am here, has anyone moded this model of radio for rpt. use? But, until I can program radios for tune up and testing....I am stuck! Oh, I had better ask. Can these radios be programmed into "Ham" frequencies in the EEPROM. I realize that I may have to adjust within the radio also, if I can get 2 meter frequencies programmed in the EEPROM. Any info on programmer and radio would be appreciated! Thanks! Tim Hardy W7TRH / AFA0TP Vashon Is. Wa. 206.850.9735
