What frequency are you on? I'll need to look at a schematic to come up with much. 73 de Eric
Eric Lowell Eastern Maine Electronics Inc. 48 Loon Road Wesley ME 04686 eme....@starband.net www.satnetmaine.com 207-210-7469 --- On Fri, 6/26/09, w4sef <w4...@localnet.com> wrote: From: w4sef <w4...@localnet.com> Subject: [Repeater-Builder] Re: GE Mastr II Fuzzy audio To: Repeater-Builder@yahoogroups.com Date: Friday, June 26, 2009, 6:14 PM Hi Lowell, Near the front end helical section of the reciever there are two crystals and a trimmer near them Also, 3 coils that need alignment. There are the ones I am talking about. I have a feeling that these are the ones that are not aligned properly. The reciever is very sensitive-about. 12 for 12 DB Sinad quieting but the audio, especially on a weak signal is distorted. Thanks for any help. Steve - In Repeater-Builder@ yahoogroups. com, Eric Lowell <elowell9756@ ...> wrote: > > I looked through my notes on the UHF version and I did'nt see anything tricky > there. What do you mean by specialized equipment? > > 73 de W1EL > > Eric Lowell > Eastern Maine Electronics Inc. > 48 Loon Road > Wesley ME 04686 > eme....@... > www.satnetmaine. com > 207-210-7469 > > --- On Thu, 6/25/09, Eric Lowell <elowell9756@ ...> wrote: > > > From: Eric Lowell <elowell9756@ ...> > Subject: Re: [Repeater-Builder] GE Mastr II Fuzzy audio > To: Repeater-Builder@ yahoogroups. com > Date: Thursday, June 25, 2009, 9:31 PM > > > > > > > > > > > > > > Seems like I used to have to inject the IF freq and tweek that up first. > > UHF or VHF? I'll look at my manuals tomorrow. > > E > > Eric Lowell > Eastern Maine Electronics Inc. > 48 Loon Road > Wesley ME 04686 > eme....@starband. net > www.satnetmaine. com > 207-210-7469 > > --- On Thu, 6/25/09, w4sef <w4...@localnet. com> wrote: > > > From: w4sef <w4...@localnet. com> > Subject: [Repeater-Builder] GE Mastr II Fuzzy audio > To: Repeater-Builder@ yahoogroups. com > Date: Thursday, June 25, 2009, 9:08 PM > > > > > Hi all, > > My spare Mastr II reciever audio is best decribed as "fuzzy/slightly > distorted. > It seems worse on a weak noisy signal. I have checked the crystal frequency > and > it is dead on. I went thru the reciever alignment and this reciever is really > hot as far as quieting goes. I suspect the problem is misalignment in the 3 > coils and trimmer cap near the helical resonator section. According to what I > have read in the manual it takes some specialized equipment that I don't have. > Can anyone advise me as to a good way to check this alignment? I am new at the > GE game so I appeciate any advice. > > Thanks > Steve W4SEF >