as one time I had a VHF one that did both 91.x and 167.
could only use one at a time but both would bring up the repeater when not in
use.
John
----- Original Message -----
From: william...@aol.com
To: Repeater-Builder@yahoogroups.com
Sent: Thursday, August 13, 2009 10:36 PM
Subject: Re: [Repeater-Builder] Re: Motorola MTR2000 Question
I believe the MTR can only do one tone code at a time.
bb
In a message dated 8/13/2009 9:19:46 P.M. Central Daylight Time,
maire-rad...@verizon.net writes:
how about one repeater but different tone codes?
or the repeater is at some other location.
John
----- Original Message -----
From: Christopher Hodgdon
To: Repeater-Builder@yahoogroups.com
Sent: Thursday, August 13, 2009 8:43 PM
Subject: [Repeater-Builder] Re: Motorola MTR2000 Question
I wish I had a picture of the repeater house. The frequency listed on the
MTR2000 is that of the schools maint. department. The other MTR2000, hook to
the other antenna, is the Schools PD. I know those for a fact. Now its time to
locate the other repeater system.
The only odd ball thing I do know is that every once in a while, when a
bus is talking to another bus or dispatch, you get a high squeal walk on over
them, but its most likely another drive not paying attention and trying to key
their radio. But I wonder if it might be the maint. since their frequency is so
close to ours.
--- In Repeater-Builder@yahoogroups.com, "Gary" <n6...@...> wrote:
>
> The UHF repeater is likely mismarked or the frequency info you obtained
for
> your school's license is inaccurate. The UHF repeater is likely the
school's
> repeater. As mentioned earlier the MTR2000 is a multi-channel radio but
can
> only repeat on the channel it is left on. Recommend you find a dealer or
> tech experienced with the MTR and who has the software necessary to
> configure it. Have them download its codeplug. Recommend you do the same
> with your school radios. A comparison of the data will likely answer a
lot.
> Gary
>
> -----Original Message-----
> From: Repeater-Builder@yahoogroups.com
> [mailto:repeater-buil...@yahoogroups.com] On Behalf Of Christopher
Hodgdon
> Sent: Thursday, August 13, 2009 4:29 PM
> To: Repeater-Builder@yahoogroups.com
> Subject: [Repeater-Builder] Re: Motorola MTR2000 Question
>
> Here's the deal, I work for a local school district, I have been kind of
> thrust into a temp. communications specialist position while we obtain
some
> new buses and working with the company that will be adding the new
radios to
> them.
>
> Over the last few weeks, we have been trying to determine the location
of
> our repeater. The place were it is listed on the FCC license paperwork
does
> not exist. I know, I am pushing them to get it updated. But that is
> another story all together.
>
> I do have access to a "radio house" located at our high school football
> field and it has two MTR2000 in it, plus two different antennas. One
> connected to one radio and one connected to the other.
>
> One radio is marked with the description of KISD PD, which is our police
> department for the district and has the following frequency pair listed
on
> it:
>
> VHF: RX 173.325 DPL 331 and TX 158.385 DPL 331
>
> The other radio is marked the following:
>
> UHF: 451.725 / 456.725
>
> There is no documentation with this equipment, the person incharge of
them
> originally left the district some years ago and no one knows anything
about
> them, expect where they are located, as far as these two boxes go and
what
> frequencies that have listed.
>
>
> Which brings me back to our department, we can find out repeater located
> anywhere physcially. Our repeater pair is listed as:
>
> UHF: 451.750 / 456.750
>
> That is according to FCC, repeater listing and other information I have
been
> able to obtain and by listening to it on a UHF amateur radio to see
which
> frequency they were on.
>
> That being said, it is possible that the MTR2000 that is marked with
the one
> UHF frequency, might actually have both pairs programmed into it, but
only
> one can run at a time, right?
>
> Is there a way to find out if there is more than one frequency is
programmed
> into the unit and if so, how might we go about that? Another reason I am
> asking is that we might be upgrading our system in the very near future
and
> I might be able to get my hands on these repeaters.
>
> Thanks in advance.
>
> --- In Repeater-Builder@yahoogroups.com, Brian Raker <brian.raker@>
> wrote:
> >
> > The radio can be programmed for multiple frequency pairs. That being
> > said, it cannot operate more than one channel / programmed pair of
> > frequencies at one time.
> >
> > -Brian / KF4ZWZ
> >
> > On Thu, Aug 13, 2009 at 3:23 PM, Christopher
> > Hodgdon<chris.hodgdon@> wrote:
> > > This is a question I have been asked and don't have an answer for.
This
> could be for either amateur operation or commercial operation, but it
> relates to the repeater itself.
> > >
> > > Can a Motorola MTR2000 setup on UHF be setup to function as a
repeater
> on more than one pair of frequencies? I know looking at the brochure
on the
> website, it says that the NO. of Frequencies are upto 32.
> > >
> > > Does that mean it can handle two different sets of repeater pairs
at the
> same time in the same radio?
> > >
> > > These are commercial frequencies I am listed at commercial, but
they are
> for example purposes:
> > >
> > > Can the following setup work with the MTR2000?
> > >
> > > Frequency Pair 1: 451.725/456.725
> > > Frequency Pair 2: 451.750/456.750
> > >
> > > Can one MTR2000 handle both of these at the same time?
> > >
> > > Thank in advance.
> > >
> > >
> > >
> > > ------------------------------------
> > >
> > >
> > >
> > > Yahoo! Groups Links
> > >
> > >
> > >
> > >
> >
>
>
>
>
> ------------------------------------
>
>
>
> Yahoo! Groups Links
>
------------------------------------------------------------------------------
