Hi George,
If you don't mind going to the trouble, that would be great. Just verifying if
the pin number/functions are the same as the Moxy would be good because I
already have the Moxy pinout.
73
Jeff KP3FT
--- On Wed, 9/8/10, George Henry <ka3...@att.net> wrote:
From: George Henry <ka3...@att.net>
Subject: Re: [Repeater-Builder] schematic and/or pinout diagram, Maxar 80,
D51TSA4000BK
To: Repeater-Builder@yahoogroups.com
Date: Wednesday, September 8, 2010, 7:45 PM
I think I have a Maxar 80 manual at the office... I will check tomorrow
morning. I think the only real difference in the connectors is that the
Maxar 80 connector has 2 large pins at the top for power, while the Moxy has
all pins the same size, and uses the first 2 in the 2nd row for power. All
the metering, audio, and PTT pins are the same... I *THINK*...
----- Original Message -----
From: "Jeff KP3FT" <kp...@yahoo.com>
To: <Repeater-Builder@yahoogroups.com>
Sent: Wednesday, September 08, 2010 2:53 PM
Subject: Re: [Repeater-Builder] schematic and/or pinout diagram, Maxar 80,
D51TSA4000BK
Hi George,
Thanks for the reply. I had downloaded the diagram for the Moxy earlier from
that website, but discovered the connector is different for the Maxar 80.
Not sure if the pinout #s are the same though. I could spend the money and
get a manual, but that is another 20 dollars and more time, plus I don't
think I need much information really, since the new target frequency is not
much higher than the original frequency and may not need retuning. It's for
a beacon transmitter, so RX tuning isn't necessary.
Jeff KP3FT
--- On Wed, 9/8/10, George Henry <ka3...@att.net> wrote:
From: George Henry <ka3...@att.net>
Subject: Re: [Repeater-Builder] schematic and/or pinout diagram, Maxar 80,
D51TSA4000BK
To: Repeater-Builder@yahoogroups.com
Date: Wednesday, September 8, 2010, 3:40 PM
I know that they are available on the Batlabs site... try
http://www.batlabs.com/nosynth.html and scroll down to the Moxy section. I
believe that the pinouts for the Maxar, Maxar 80, and Moxy were all the
same.
George, KA3HSW / WQGJ
>
>From: KP3FT <kp...@yahoo.com>
>To: Repeater-Builder@yahoogroups.com
>Sent: Wed, September 8, 2010 1:58:15 PM
>Subject: [Repeater-Builder] schematic and/or pinout diagram, Maxar 80,
>D51TSA4000BK
>
>
>Hi all,
>Does anyone have a scanned schematic and/or a pinout diagram for a Maxar 80
>lowband? I moving one that is presently at 49.520 MHz, up to 50.065 MHz,
>but
>have no idea what the pins are for PTT, etc. There is no microphone or
>other
>cables that came with the radio. Thanks for any help.
>Jeff KP3FT
>
