Dear Jared, > ... I think you’re speaking of just using the anchors?
Actually not. We are owner of Atlas probe: 35603 When I setup a new measurement I am asked to enter a number of probes. So I assume only probes are used for my measurement. Isn't it ? // Hans -----Original Message----- From: Jared Mauch <[email protected]> Sent: Wednesday, May 22, 2019 3:31 PM To: Mayer Hans <[email protected]> Cc: [email protected] Subject: Re: [atlas] RFC1918 probes > On May 22, 2019, at 8:40 AM, Mayer Hans <[email protected]> wrote: > > > > Dear All, > > Looking at the result of a traceroute measurement I see very often that first > hop has a RFC1918 address. > These days a found a result where the first 3 hops are showing > something like 192.168.x.y Of course this could falsify the result especially > for response time. > Is there a way to select only Atlas probes which are located in non RFC1918 > networks ? > If not it would be nice to have such a possibility. I think you’re speaking of just using the anchors? - Jared
