Thanks! That gives me a good roadmap.
Chris On 10/26/2015 1:38 PM, Lorne Tyndale wrote: > Hi, > > I've never tried to do what you're doing, however it should be > reasonably easy to set up a pause / unpause GPI. > > First you'll want to do is to enable event pausing in rdadmin --> Manage > Hosts --> rdairplay > > Then create a macro cart using the PB macro. PB - push button - will > push which ever button on the left hand side of rdairplay that you tell > it to. So a: > > PB 1! > > will do the same thing as if you used the mouse and clicked on that > first button which - if pause is enabled - will cause that audio to > pause. Run the macro again and it'll resume or start - like a toggle. > > Next set up a GPI on the Rivendell box and set it to run that macro in > RDAdmin. To test you could set up a simple push-button which would > pause / unpause the audio output. If your Rivendell computer has a > serial port on it you could likely even use the serial port modem > control lines for the GPI if you didn't have another way to handle > GPI's. For setting up the modem control lines as GPI's, have a look at > the post I did a while back: > > http://caspian.paravelsystems.com/pipermail/rivendell-dev/2015-April/022658.html > > I can't comment on the SAGE box as I've never set up contact closures on > one of those. > > Lorne Tyndale > >> >> I apologize up front, I suspect this question is probably >> answered somewhere in the wiki or documentation but I have not >> found it. >> >> >> I have a Sage Digital ENDEC. >> It has a relay-closure on the back for signalling that >> the ENDEC has hijacked my broadcast. >> >> I would like to have that signal a "pause" to my playback. >> A small bit of dead-air around the margins is OK. >> >> I want my listeners to miss little or none of >> the content. >> >> I want it to play to the end of the interrupted cart >> and then continue on with the log as per the >> current time. >> >> I think this means I need a GPIO to sense the relay closure. >> After that, I'm not sure what happens. >> >> Chris Howard >> Classic Book Radio >> >> (I've been away from my Rivendell configuration tasks for >> awhile. But now we have most of our equipment and I'm >> back at it. We hope to have our LPFM on the air before >> end of this year.) >> >> _______________________________________________ >> Rivendell-dev mailing list >> Rivendell-dev@lists.rivendellaudio.org >> http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev > > _______________________________________________ Rivendell-dev mailing list Rivendell-dev@lists.rivendellaudio.org http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev