> As I said, I was running with the rpc.cfg recommended in the manual. > This specifies an ARM710 processor, not the default StrongARM. > > As I also said, I can't change anything through the menu because once > I've used the menu the virtual screen goes blank so I can no longer > use the emulated machine. > >> Can you also provide the contents of the rpclog.txt file which is >> generated when you run RPCEmu? > > Attached. I did change the CPU type to ARM610 in case it helped. In > this session, I was able to use the menus once (I opened the Settings > dialog, then clicked cancel), and the screen was fine. However, I then > opened the menus again, and pressed Escape, and the virtual screen > went black. > > Also, I still had the boot problem: when I initially ran rpcemu, !Boot > was not executed, nor was any of the CMOS configuration respected > (screen mode &c.). On clicking Shutdown and Restart (from the taskbar > menu), the machine rebooted properly.
Using the details in the rpclog.txt I have replicated your environment as closely as I can. I tested RPCEmu and it worked fine with none of the problems you have described. The environment was a newly installed version of Ubuntu 10.10, and I have confirmed I have used the same kernel, Allegro version, compiler and configuration. The most obvious difference left is the ROM you are using. Is it possible the ROM is corrupt in some way? We have had people reporting problems on the mailing list before, and the cause was a corrupt ROM. Can you provide details of how the ROM was obtained? Thanks Matthew _______________________________________________ Rpcemu mailing list [email protected] http://www.riscos.info/cgi-bin/mailman/listinfo/rpcemu
