Guys,
I found an error on one of my CDEF. The new is:
'CDEF:input=cnxs,UN,0,cnxs,IF' \
'CDEF:Cnxs=input,300,LE,input,300,IF' \
'CDEF:CnxsOrange=input,600,GE,300,input,300,-,IF' \
'CDEF:CnxsRed=input,600,GE,input,600,-,0,IF' \
'AREA:Cnxs#00FF00' \
'STACK:CnxsOrange#FF9F00' \
'STACK:CnxsRed#FF0000' \
Drawing is fine except that UN values are set to -300. I understand why
since input is not higher than 600 with it is equal to 0 (CDEF #1 says if
value=UN, then value=0
My previous email was:
QUOTE
I still try to create my layered area, depending on the value.
I intend to have (G=Green, O=Orange, R=Red) as:
GGGGGOOOOORRRRR
GGGGGOOOOOR
GGGGGOOO
GGG
GGGGGOOO
To build this, I defined the following:
'CDEF:Cnxs=input,300,LE,input,300,IF' \
'CDEF:CnxsOrange=input,600,GE,300,input,IF' \
'AREA:Cnxs#00FF00' \
'STACK:CnxsOrange#FF9F00' \
With this, I was expecting to have
a green layer for values between 0 & 300
A orange layer for values above 600
Partial orange layer for values between 300 & 600.
I dont understand why it fails. From my poor RPN understanding, the Orange
CDEF is correct.
But I have on my drawings AREA with orange values above 600.
If I succeed doing this, I guess I could add a 3rd layer (Red) for values
above 900.
Can someone help?
Thanks
Brgrds
UNQUOTE
Laurent LEVIER
Systems & Networks Security Expert, CISSP CISM
--
Unsubscribe mailto:[EMAIL PROTECTED]
Help mailto:[EMAIL PROTECTED]
Archive http://www.ee.ethz.ch/~slist/rrd-users
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
