Gentlepersons,
As part of our development of an RT driver for the Cyclades-Y
multi-serial port card I have finally upgraded to RTL3.0, and after a
bit of trouble have recompiled my code, for one of our CPUs anyway, and
it all seems to work. I am using the API V1 still but will one day
upgrade in my copious free time.
Some of our CPUs use the rt_com module and that also seems to be OK
except for one thing. You need to do the following to load the rt_com
module:
setserial /dev/ttyS0 uart none
insmod rt_com
Now, I want these machines to boot up and load whatever they need to
make them run, including all the RT modules. With the older version of
rt_com I could put
insmod rt_com
into the rc.local file. This no longer works, mostly I think due to the
setserial stuff. If I put both the setserial command and the insmod
rt_com command into rc.local it doesn't work.
Any suggestions?
Theo
--
Dr. Theo ten Brummelaar
The CHARA Array-Georgia State University-Mount Wilson Observatory
http://www.chara.gsu.edu/~theo Ph: 626-796-5405 Fax: 626-796-6717
-- [rtl] ---
To unsubscribe:
echo "unsubscribe rtl" | mail [EMAIL PROTECTED] OR
echo "unsubscribe rtl <Your_email>" | mail [EMAIL PROTECTED]
--
For more information on Real-Time Linux see:
http://www.rtlinux.org/rtlinux/
