Thanks Ken. 30 degrees was my assumption and that was all I was looking for.
Joanthan --- In [email protected], ken garber <garber.ken@...> wrote: > > If I read this right.... > > I have a trio of broad curved turnouts. I forget what I ordered but the > inside curve (the mainline) would have been a minimum of about 44 inches. > > Three of them make a 90 degree turn so one is therefore a 30 degree arc. > > Does that sound reasonable? > > > Ken > > > > On Fri, Jun 15, 2012 at 1:48 PM, ken garber <garber.ken@...> wrote: > > > I have a couple of custom TOs from Tomalco. Once I find out how to > > measure the arc, I can check them out. > > > > Of course I have to remember what radii they are. > > > > Ken > > On Fri, Jun 15, 2012 at 1:23 PM, Jonnyspeed <jonathan@...> wrote: > > > >> Hi John, > >> > >> I'm not sure what you mean? I would like to know what the arcs are in > >> degrees for the #6 curved turnout assembly. > >> > >> Thanks, > >> Jonathan > >> > >> --- In [email protected], rxman46321@ wrote: > >> > > >> > If you asked, all thier products are available in any scale. There is a > >> > reasonable charge to set it up but then it goes into stock and is > >> available > >> > for all. They did a custom 44 inch, 40 inch and a 36 inch curve > >> template for > >> > me that was not "available". > >> > > >> > John Griffin > >> > Des Plaines Valley > >> > > >> > >> > >> > >> > >> > ------------------------------------ Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/S-Scale/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/S-Scale/join (Yahoo! ID required) <*> To change settings via email: [email protected] [email protected] <*> To unsubscribe from this group, send an email to: [email protected] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
