Jeff's question is a good one, and also says a lot about the current state
of S gauge.  Thirty years ago, any S gauger would have been able to answer
it.  There wasn't much RTR stuff available, and everyone had to roll their
own. No one was modelling in styrene yet, epoxy was new, and ACC hadn't
been dreamed of yet.  .  Many S gaugers were making things from brass, and
the old S Gauge herald was full of articles on scratchbuilding locos and
converting Flyer, often using brass.  They mostly soldered brass items
together with a torch, using wet cotton balls to prevent nearby solder
joints from mekting.  Resistance soldering is probably even better.  SSL&S
was producing brass loco kits and lost wax brass castings of parts for
superdetailing.

Jeff:  when you get a chance, check out some of the articles in the old
Herald.  You will soon learn about building in brass.  It's a fascinating
subject.

Tom Jarcho



S-Trains list sponsor: http://www.americanflyertrains.com
All the Flyer you desire...books and accessories too!

To UNSUBSCRIBE from this list send a note to [EMAIL PROTECTED] 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ 


Reply via email to