RE: [SA-list] Senssoft Sensors?

[Ryan Neily]

I am currently using the serial port connected sensor...  Will there be any
support for this in Servers Alive other than satemp.exe?

Ryan Neily



                                                                                       
                                                
                      "Dirk Bulinckx"                                                  
                                                
                      <[EMAIL PROTECTED]        To:       <[EMAIL PROTECTED]>          
                                               
                      u>                       cc:                                     
                                                
                      Sent by:                 Subject:  RE: [SA-list] Senssoft 
Sensors?                                               
                      [EMAIL PROTECTED]                                                
                                                
                      stone.nu                                                         
                                                
                                                                                       
                                                
                                                                                       
                                                
                      11/06/2003 03:38                                                 
                                                
                      PM                                                               
                                                
                      Please respond to                                                
                                                
                      salive                                                           
                                                
                                                                                       
                                                




If you use a sensor that is SNMP enabled you can use the SNMP check of
Servers Alive.


dirk.



-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf Of Ryan Neily
Sent: Thu Nov 06 9:21 PM
To: [EMAIL PROTECTED]
Subject: [SA-list] Senssoft Sensors?






Does anyone have a better solution than using SaTemp for monitoring
SensorSoft Sensors in Servers Alive?  I've been using it for sometime,
but it leaves alot to be desired...

Did I see someone mention that this would be enabled in ServersAlive to
be an internal check?

Ryan Neily

To unsubscribe from a list, send a mail message to [EMAIL PROTECTED]
With the following in the body of the message:
   unsubscribe SAlive



To unsubscribe from a list, send a mail message to [EMAIL PROTECTED]
With the following in the body of the message:
   unsubscribe SAlive


To unsubscribe from a list, send a mail message to [EMAIL PROTECTED]
With the following in the body of the message:
   unsubscribe SAlive