Your route table is bad...remove first route. And missed local loopback if.
----- Original Message ----- From: "TheStar" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, November 12, 2002 5:46 AM Subject: [Samba] Which list for general help? > > Hello, I am having enormous difficulty in getting samba to work correctly on the > local network when the local network is on eth1. > > I have never had any trouble with samba when I used eth0... > > Here is my routing table... > > Kernel IP routing table > Destination Gateway Genmask Flags Metric Ref Use Iface > 255.255.255.255 * 255.255.255.255 UH 0 0 0 eth1 > 192.168.1.0 * 255.255.255.0 U 0 0 0 eth1 > 192.168.0.0 * 255.255.255.0 U 0 0 0 eth0 > default 192.168.0.1 0.0.0.0 UG 1 0 0 eth0 > > > This same computer works perfectly in every other area. eth0 is dedicated to the > internet and masq's the network. > > > findsmb can only see the local computer. > > I do not have an interfaces line in my smb.conf, and adding it apparently makes little > difference. > eg, > without the line, it apparently defaults to eth0 > With the line interfaces = eth1, the ip of the local computer changes, to the ip that eth1 > uses, however, findsmb can still only see the local computer. > > The other computers on the network can't see this local... > > Any suggestions? > > I have recently subscribed, but since I haven't recieved any messages for the past 24 hours, I do not know if I subscribed correctly, hence, could you please 'cc' me? I do not mind having several copies of a reply... > > Thanks in advance! > -- > To unsubscribe from this list go to the following URL and read the > instructions: http://lists.samba.org/mailman/listinfo/samba -- To unsubscribe from this list go to the following URL and read the instructions: http://lists.samba.org/mailman/listinfo/samba
