> -----Original Message----- > From: Jeff Morrow [mailto:[EMAIL PROTECTED]
> On the windows side, the network utilization monitor says > that network > load stays around 25-30%. It occasionally gets as high as 40%. CPU > usage on the windows side is negligible. On the linux side, > top reports that smbd is taking about 30% CPU. > > I'm confused by the fact that neither network utilization nor > CPU usage on either computer is getting anywhere near 100%. I doubt you'll ever hit 100%. The most basic reason is you're using a PCI bus ethernet controller. A quick check of the specs for the RTL8169 you mentioned shows it's a 32-bit, 33/66 MHz PCI card. If you're using it in a 33 MHz slot, your maximum bus bandwidth is only a little over 1 Gbit/sec. If your disk controller is sharing the same bus, that means you can do maybe 500 Mbit/sec, tops. If it's in a 64 bit slot, you can double those numbers, but you're still not leaving much of a margin. -- To unsubscribe from this list go to the following URL and read the instructions: http://lists.samba.org/mailman/listinfo/samba