Anthony Messina wrote: > stephen, might you try setting: > > hosts allow = 10.0.0.0/8 > > or change the network/mask bit for each lan you'd like to allow > > and: > hosts deny = 0.0.0.0/0 > > and: > interfaces = eth0 > bind interfaces only = yes > > change eth0 to whatever eth* interface your lan is connected to, and > also add "lo" if you use printers attached to this samba server. this > will tell samba to only bind to the interfaces that you have configured > here and may route broswing properly. > > anyone else here have any suggestions?
We did interfaces = 10.10.10.12/24 and remote announce = 10.10.10.255/HEDLIN-LAUDER following the smb.conf man page, but that had no discernable effect. -Stephen- -- To unsubscribe from this list go to the following URL and read the instructions: https://lists.samba.org/mailman/listinfo/samba