[EMAIL PROTECTED] wrote: > > [EMAIL PROTECTED] wrote: >> >> Herb Lewis wrote: >>> run the following to find out where it should be >>> >>> smbd -b | grep CONFIGFILE >>> >>> >>> [EMAIL PROTECTED] wrote: >>>> Ok, that is how I installed it, but the other answer from Terry was: >>>> >>>> "Yes in /usr/local/etc/smb.conf" >>>> >>>> The config file was in neither. Most of the directories were in the >>>> 'usr/local/samba' and there was nothing in the '/usr/local/etc' as far >>>> as >>>> samba goes. >>>> >>>> I would have thought that it would have put a smb.conf in one of the >>>> directories or at least an example in one. I just want to make sure >>>> that >>>> I get it in the correct place. >>>> >>>> Thanks. >> >> I tried that and it looks like the shared object libtalloc.so.1 is not >> found. I searched for it on the server just to make sure it was not in >> the wrong place or did not have a link to it, but it is no where to be >> found. Guess I'll have to find out where to get it installed from. >> >> Any ideas on that? >> >> I may should have just left 3.0.30,1 on there and gone with that. :) > > Whoops my bad. I had a typo. Now I need to know for sure where the > libtallco.so.1 goes. >
I just uninstalled it and ran the configure again and I noticed a few WARNINGS about sys/mount.h and netinet/ip.h present but cannot be compiled. I am not sure what that is about. I think I'll just go back and use the 3.0.30 port and install it. Hopefully there is not too much that I will be missing and maybe I can just upgrade to 3.2 later on. Thanks. -- Scott Mayo - System Administrator Bloomfield Schools PH: 573-568-5669 FA: 573-568-4565 Question: Because it reverses the logical flow of conversation. Answer: Why is putting a reply at the top of the message frowned upon? -- To unsubscribe from this list go to the following URL and read the instructions: https://lists.samba.org/mailman/listinfo/samba