Hi Thierry I had done this before I sent the Mail and I have verified again.
Yes, the scanner is known but it does not initialize properly on my system. Martin Am 20.05.20 um 23:33 schrieb Thierry HUCAHRD: > Le 2020-05-20 22:39, Martin Gubser via sane-devel a écrit : >> On Linux Mint 19.2 and 19.3 my TS8050 does not initialize properly. >> >> When I start XSANE the error message "device busy" is displayed. >> >> I have found the following work-around: >> - switch off the TS8050 >> - perform "scanimage -T" in a command window. Result: "no Sane >> devices found" >> - switch on the TS8050 >> - perform "scanimage -T" again. Sometimes the steps from "switch off >> the TS8050" to here have to be repeated. >> - Start XSANE again from the menu. >> >> The TS8050 is connected via USB. >> >> I have quite a fast computer and a race condition or other timing >> problem could well be the cause. >> > Hi Martin, > Make sure you update your Sane installation. > Your device is known! > In a console type the commands below: > sudo add-apt-repository ppa:rolfbensch/sane-git > sudo apt-get update > sudo apt install libsane libsane-common sane-utils > > Thierry > >> Best regards, >> Martin
