Hi, Some general comments:
1) This is not a write-only list. Please read the comments we write and, if something is unclear, respond to them. 2) Please don't make up a new subject for every article you write. Stay in the same thread, just reply to you own or somebody else article in this thread. Otherwise we must search the list for your name to find out what you aleady tried. On Sat, Nov 16, 2002 at 02:13:36PM -0700, Karl F. Larsen wrote: > I read "man sane-plustek" 4 times. It said clear as a bell that > ALL I need in the file plustek.conf is 2 lines. Here is what I have now > on this computer: > > # Plustek-SANE Backend configuration file > # For use with Plustek parallel-port scanners and > # LM9831/2/3 based USB scanners > > [usb] 0x04b8 0x01f > device /dev/usb/scanner0 Either remove the ids after the [usb] line completely or at least use the correct ones. It has been already said that the product id is 0x010f, not 0x01f or any other variant of this. The scanner is still found by sane-find-scanner? If nothing else helps, create a plustek.conf file with nothing but: [usb] device /dev/usb/scanner0 > It can't be much simpler than that, and that is what the man > page said to do. Alas when I try Xsane and scanimage it comes up with > "Can't find scanner". Please send us the debug.log generated by: SANE_DEBUG_PLUSTEK=255 scanimage -L 2>debug.log > At this point I'm dead. I don't understand sane, and if the man > page is wrong then what is right? The man page is not wrong as far as I can see. > Since 0x04b8 means Epson do you think sane is looking for Epson.conf? No. > I only have plustek.conf in /etc/sane.d/. What do you mean by that? Did you remove all the other config files? In this case you destroyed your sane installation. Please reinstall. You need at least dll.conf. Bye, Henning
