Note that the scanner works in windows on the same computer with drivers from Nikon. I have also tested the HP Scanjet 3c and it works fine with sane. Oliver Rauch wrote:
>How long is the cable between scanner and controller? > 105 cm, including terminator. >Is the termination of the controller turned on? > It does not have an on/off switch. It's just a pass through. As far as the controller goes, there is nothing I can change about the terminator. >Sometimes it helps (although it is not standard conform) >to remove the terminator on the scanner. >But at first I would try to set up a standard conform scsi bus >(termination for scanner and scsi controller). > It does the same thing with or without the terminator. It randomly stops scanning. > >On Sunday 15 December 2002 01:54, you wrote: > > >>Oliver Rauch wrote: >> >> >>>The Nikon AX-110 is the same scanner as the UMAX Vista S6E. >>> >>>Please tell me about: >>>-sane-backends version >>> >>> >>1.0.8-r2 (latest gentoo linux ebuild) >> >> >> >>>-kernel version >>> >>> >>vanilla 2.4.20 with dc395-141.tar.gz patch from >>http://www.garloff.de/kurt/linux/dc395/ compiled with gcc3. >> >> >> >>>-scsi driver kernel module name and options you use >>> >>> >>dc395x_trm module with no options >> >> >> >>>- how does your scsi bus look like (devices, cables, termination), >>> internal and external >>> >>> >>External from the card looks like a parallel port and has the same >>number of pins. The scanner end of the cable has 50 pins. There is a >>terminator on the scanner. It is the only device on the bus. The SCSI >>host card has an internal connection (50 pin) but nothing is on it. >> >>When the scanner halts, the ready light (which is normally on all the >>time) flashes without a pattern. The option light is always off (I >>don't have an option) and power is obviously always on. >> >> >> >>>Oliver >>> >>>On Saturday 14 December 2002 20:57, Kenneth Heafield wrote: >>> >>> >>>>I have a Nikon AX-110 SCSI (aka Scantouch 110) scanner on a Tekram Ultra >>>>SCSI DC-315. Sane detects the scanner correctly, but only if I run it >>>>as root. It can get previews and full scans part of the time. More >>>>than half the time, the scan will halt partway through. The scanner >>>>stops moving and emits a high frequency sound. SANE does not report any >>>>errors. It just waits for more data. Aborting the scan or preview does >>>>not work. The only way I know to stop it is to kill sane and restart >>>>the scanner. However, no scans will work after that unless I rmmod the >>>>module for my SCSI card and insmod it again. Sometimes, I cannot rmmod >>>>the module or sg because the device is busy. >>>> >>>>_______________________________________________ >>>>Sane-devel mailing list >>>>sane-de...@www.mostang.com >>>>http://www.mostang.com/mailman/listinfo/sane-devel >>>> >>>> > > >
